Information

A water based colour stain remover containing a combination of emulsifiers and solvents with a friendly pH leaving skin clean and without irritation. 

Hair colour that is allowed to remain on the skin will cause some staining. This applies to semi-permanent and certainly to permanent colours. It is diffcult to apply colour without this happening. The extent to which the colour is visible depends on skin tone in relation to the colour applied, the type of colour (semi permanent / permanent) and the time left on the skin.

Ingredients

Water, Alcohol Denat, Oleic Acid, Laureth-8, Sulphated Castor Oil, Benzyl Alcohol, Ethoxydiglycol, Eucalyptus Oil, PEG-40 Hydrogenated Castor Oil, Aminomethyl Propanol, Citric Acid, Methyl Paraben, Fragrance, BHT.

Not Tested on Animals

How to Use

• Using cotton wool, apply REMOVE IT around the entire hairline before colouring, this helps prevent discolouration by reducing the formulation of colour on the skin.
• If colour is allowed to stain the skin, then the combination emulsifiers and solvents helps to lossen the colour molecules and emulsify them from the skin.
• Should skin staining be evident after colour has been rinsed from the hair, REMOVE IT on cotton wool will assist with removal.
• REMOVE IT should not be used in the vicinity of the eyes. Should product enter the eyes, thoroughly rinse with water until irritation subsides.

Should irritation persists seek medical attention.

Warnings

• Keep reach out of children.
• If swallowed do not induce vomiting. Give a glass of water or contact a doctor immediately, or the poison information center, Australia 131 126, New Zealand 0800 764 766
• Do not allow product to come in contact with eyes. Should this occur rinse eyes thoroughly with water. If any irritation persists seek medical attention.